Tarnaq @ Tarnaq @lemmy.world

Posts

1

Comments

12

Joined

2 yr. ago

So pausing the print appears to be the issue. I printed 3 minis today without pausing, and they all came out perfectly.

Thank you for all the responses!

I'm hoping that's the issue. I'll find out tomorrow, and if not then I'll look into the z axis.

I've paused all the prints I've done (I've only had the printer for about a month), I'm hoping that's the issue. If not I'll definitely look into the z axis screw.

I updated to the newest firmware before I started printing (I've only had it for a month or so).

I'll try without the pause, and then look into the z axis of that doesn't solve the problem.

I don't think it's the render, there's no ridge on the model when I'm supporting or slicing.

I generally have my lift set to 7mm, which should be enough. If it continues even if I don't pause the print, I'll give it a try.

That's what I'm beginning to suspect, other prints that have had ridges or offsets I paused as well.

It's not supposed to be there, there was no ridge when I was supporting and slicing.

It may be because I paused the print to check raft adhesion. I'll try some prints tomorrow without pausing.

The preview does not have a ridge, nor was there one when I was supporting and slicing.

I should add that I'm using rafts and lifting the prints 5mm.

There's no nuance here. Sex with a pre-pubescent child is, by definition, pedophilia. No matter what time it takes place in.