7
comments
No. First hit it'll chip or break. For ice you need steel.
12 0 ReplySounds terrible. But I encourage you to try it, it is a good exercise in understanding the material better. Maybe try a smaller scale first
8 0 ReplyI don't know what PLA cost but this is $25 and will actually do the job.
8 0 ReplyHow big is the printer? This sounds like a very expensive, bad idea.
2 0 ReplyI was thinking something like a chisel, but yeah, these comments suggest even that would break before the ice.
1 0 ReplyTry salt?
1 0 Reply
No
2 0 Reply
7
comments
Scroll to top