Bambu Lab’s Controversial ‘Authorization Control’ Hits Budget 3D Printers
Bambu Lab’s Controversial ‘Authorization Control’ Hits Budget 3D Printers
You're viewing a single thread.
I have not updated my x1 firmware and never will be.
I blocked mine from the internet for good measure too.
I did this, but experienced a lot of issues connecting to it afterwards. Constant disconnects and it taking several minutes after opening Orca/Studio to find it.
Any advice, as I'd like to go back to LAN Mode?
Cheers
I currently have my P1S in LAN mode and use HomeAssistant to control it, using thr ha-bambulab integration. Does everything I need
Cheers, HA integration is on the plan for the future, I just strugle with time these days with a small kid and work.
Roll back the firmware to a version that worked. You still can do that.
I wish I could.
Need the newer FW to use the drying function of the AMS2.I'm considering going back to LAN and just dealing with it though. I really prefer Orca over Studio
It would appear you are now trapped by Bambu into their product system.
May God ha' Mercy on your Soul.