Looks like you're a few months away from this persons situation: https://www.doityourself.com/forum/water-heaters/582934-water-heater-leaking-both-element-panels.html
relevant quote: "In your case the leak is probably in the metal side of the tank somewhere covered by the layer of insulation."
For those of us getting blocked for using a VPN:
The thermal overload “jammed”, so the heaters never stopped heating. The pressure release valve operated and made a fucking mess. I was away when it happend. When I came back, as soonas i opened my house door it felt like a jungle in there … warm and damp air Could have been worse. The pressure went up so high that the top cover warped.
There should be a pressure relief valve that prevents any kind of dangerous levels of pressure buildup. The result is that they spill water all over the floor and make a mess but there should never be any kind of high pressure. This is really important because hot water heaters can trigger an extremely violent explosion otherwise.
Hopefully the deformation in your picture was just warping due to heat or something rather than pressure.
Here is an alternative Piped link(s): https://piped.video/watch?v=9bU-I2ZiML0
Piped is a privacy-respecting open-source alternative frontend to YouTube.
I'm open-source, check me out at GitHub.
