Obscure screw added so appliance cannot be disassembled
Obscure screw added so appliance cannot be disassembled
Basic blender went bad (motor ran but spindle wasn't rotating). I wanted to disassemble to see if it could be repaired. Three of the four screws were Phillips head. I had to cut the casing open in order to discover why I couldn't unscrew the fourth. It was a slotted spanner.
You're viewing a single thread.
That's a flathead with a bead welded in the middle. Source a local dremel, some earplugs and eye pro, and do some quick converting.
Oh wait I think I understand the image. You had to saw the plastic apart to expose the screw. Yeah fuck those dudes. I guess another option would've been to get a cheap screw driver and modify it with a dremel? Either way, fuck Kenmore.
Oh wait it think I understand the image. You had to saw the plastic apart to expose the screw. Yeah fuck those dudes. I guess another option would've been to get a cheap screw driver and modify it with a dremel? Either way, fuck Kenmore.
Wait... Oh.
They didn't have to do anything destructive to "expose" the screw. They were too lazy to find a better way to see the bottom of the hole it was in.
That's a standard spanner-head screw. No welding required. The bits and drivers are not so hard to come by, or make.