Utensil Holder
Utensil Holder
Assistive tech for people that have trouble holding forks/spoons/etc. Made from my favorite lesser known material, polyhydroxyalkanoates, which is fully biodegradable in any biome. Anyone else making AT for people?
Cool. I've never seen PHA before. What printer are you using for it? Is it any harder to print with?
I use it at work (a library makerspace) in an Ultimaker S5 Pro, an Ender 5 Pro, and a Snapmaker Artisan. It's actually somewhat easier to print with than PLA, except that wide flat parts warp pretty terribly? But there's ways to overcome that!
Wow, this stuff looks cool. "A drop of fossil energy use by 95% and greenhouse gas emission by 200% can be achieved by substituting petroleum-based polymers with PHAs.4 Therefore, PHAs have the potential to contribute to a green industrial evolution." (source: https://pubs.rsc.org/en/content/articlehtml/2021/ra/d1ra02390j)
Oh that is very interesting! I guess the main way that they decompose is through PHA depolymerase--according to ChatGPT a lot of the species that have been tested in the decomposition of PHA are bacteria. It would be interesting to try inoculating some samples of PHA with different mushroom species as well. It would be really great if PHA could be fully-decomposed into proper food-safe compost.
Right?! I wish I could also get it in sheet form for our vacuum thermoform machine
What sort of cost per kg difference is PHA over "regular" PLA? I would be willing to give it a shot, but I have a hard time throwing $40 at a spool as it is.
It's not too bad, if you consider the huge range of prices for PLA. Like Matterhackers "Build Series PLA" is $0.02/g at the low-ish end while Ultimaker's "Tough PLA" at the high-ish end is $0.07/g. Filaments.ca's "Regen PHA" is between those at $0.05/g.
So, if you're trying to use the cheapest filament possible? Probably not a great choice. On the other hand, there's literally only like 3 people selling PHA filament right now, so you'd think it'd be more expensive than ANY brand of PLA. That makss me wonder if it's relatively cheap to produce. If so, it may come way down in price if it catches on and becomes more available, right? I hope, anyway.
Where do you source your filament, and what settings are recommended?
The only 3 sources I'm currently aware of are filaments.ca, colorfabb, and beyondplastics. I've found them to be relatively pretty similar