Just upgraded, does anyone have pointers for when I unbox/setup?
Just upgraded, does anyone have pointers for when I unbox/setup?
![the background blur](https://lemmy.world/pictrs/image/28ed324e-6568-4792-8f38-f35ad3490ba9.jpeg?thumbnail=256&format=webp)
![](https://lemmy.world/pictrs/image/28ed324e-6568-4792-8f38-f35ad3490ba9.jpeg?thumbnail=1024&format=webp)
I know it’s only a 6” but that’s all I need right now, couldn’t justify the extra expense for the 8” at the moment.
You're viewing a single thread.
All comments
12
comments
Check the calibration:
- Confirm that the outfeed table is parallel to the cutter head.
- Confirm that the outfeed table is level with the top dead center of the cut.
- Then confirm that the infeed table is parallel to the outfeed
- Lastly confirm that the fence, when set to 90, is square to the outfeed table.
This should all the the case right out off the pallet but it's worth a check.
4 0 ReplyAdding on to this calibration comment that an engineer square is much more accurate for setting up machines than a carpenters square (which are often knocked out of alignment).
4 0 Replyhttps://www.youtube.com/watch?v=Hg53x5W7YOc
The wood and plastic squares are super easy to adjust.
1 0 Reply
12
comments
Scroll to top