I made this 2 piece tpu case for telescope lenses.
I made this 2 piece tpu case for telescope lenses.
This was a very long couple of prints over 30 hours combined. It's for an Orion telescope that's why the Orion drawing.
You're viewing a single thread.
All comments
4
comments
What software did you use to model it?
2 0 ReplyNot OP but Fusion 360 could get this done pretty easily.
Plus the hobbyist license makes it free to use.
1 0 ReplyThis was all tinkercad believe it or not. But if you need something stronger check out freecad.
1 0 Reply