3D printed drone build for drone beginners?
3D printed drone build for drone beginners?
I'm looking for a well documented 3D printed drone build for beginners to drone flying.
I'm not new to 3D printing and have a degree in electronics so I have quite a bit of experience soldering and working with electronics. I even used to work for a drone company and even contributed to Ardupilot development, but I've literally never flown a drone (successfully) before.
My main interest is just getting into the hobby a bit, learning how to fly it, and getting some cool drone footage. Eventually I may want to get into FPV.
I want to start with a 3D printed design because it is likely I will break this drone quite a bit while I am learning to fly and I figure it will be cheaper and faster to be able to print a new body when I need it.
Does anyone have a design they can recommend? I'd like one that can at least support a GoPro on it.
You're viewing a single thread.
I have made this. It may be a little what you are looking for, but it is definitely not well documented. Gopro holder is not yet in repo, i am going to add it.
Thanks I'll look at this. Any recommendations for electronics for this?
This is my current build:
- Speedy Bee F7 V3 stack
- T-Motor VELOX VELOCE V2207.5 V2, 2550KV motors
- FrSky Archer RS receiver
- DAL T5047C propellers
- Kavan 4S battery
With this frame you should use a stack or all in one. Four single motor ESCs would be impractical. When searching for a controller you may want to check if it is supported by inav or ardupilot to keep your options open. All boards are supported by betaflight, but it's not very beginner friendly.