iFixit says the Switch 2 is even harder to repair than the original
iFixit says the Switch 2 is even harder to repair than the original
Be extra careful with your new console.
You're viewing a single thread.
I honestly don't care how difficult it is, only if it's possible, if it's cost-effective, and if there are any fucking corporate shenanigans that intentionally make it harder.
I don't care about the difficulty
Nintendo better not have made it difficult
uh
I didn't say that, you just made it up so I'm not sure what your point is.
I honestly don't care how difficult it is,
only if (...) there are any fucking corporate shenanigans that intentionally make it harder.
Verbatim quote ya doofus
I'm well aware of what I said 2 hours ago, thank you. Is there a point you'd like to make?
Also the personal insults are not warranted.
The point is it is harder because they wanted to make it harder. What one could call "corporate shenanigans"
Well that sucks but I still don't understand why I'm being quoted.
I honestly don't care how difficult it is, only if it's possible
Can you think in the relationship of the two variables?
Bruh just likes a challenge.
...wat
The more difficult it is to repair something, the less possible it becomes to repair it.
Damn-near anything is possible to repair with the right training and equipment but there is a very wide spectrum between what an average person can do with tools they can easily pick up at any hardware store for cheap and a little common sense and some YouTube videos to guide them, and repairs that require specialist knowledge and equipment.
When something is made more difficult to repair, it slips further into that specialist end of the spectrum, so it's possible for less people.
For most people: the more difficult, the more expensive to get fixed
The more difficult it is to repair something, the less possible it becomes to repair it.
That's not true.
what an average person can do with tools they can easily pick up at any hardware
The tools someone has has nothing to do with difficulty.
Is it easier or harder to tighten a bolt without a wrench?
It's neither, it's impossible
You could use pliers, you could very carefully hit the corners of the head in a clockwise direction with a hammer, you could spend a lot of time training the strength in your hand and arm to tighten it by hand, you could use a dremel, saw, or file to cut a slot into it and tighten it with a screwdriver
But it's a lot easier to use a wrench.
NUH UH IT'S IMPOSSIBLE
(/s)
That's not repairing it, that's just breaking it further.
You know, I'm pretty certain at this point you're trolling, but I'm curious to hear how you justify this
If the reason something is broken is a loose or missing bolt, how does tightening that bolt with pliers instead of a wrench equate to breaking it further?
Gonna need some elaboration on that last point. You're saying having appropriate tools for the job and the difficulty of the job have no relationship? Are you against right to repair? It seems implicit in your comments.
You're saying having appropriate tools for the job and the difficulty of the job have no relationship?
Typically not having the right tools makes it impossible, not hard.
Are you against right to repair? It seems implicit in your comments.
How the hell do you reach that conclusion? Where's the logic there?
That's not true.
The tools someone has has nothing to do with difficulty.
No way you aren't ragebaiting
This is based on what?
That's... What the repairability score is.
I wasn't talking about the repairability score. I was talking about the title of this article stating that it's "harder" to repair than the Switch 1.
Yeah, it is harder to do. Specifically
- you need to remove stickers in a way that you can replace them, if you want to keep them looking good
- You need to undo glue, iFixit used isopropyl alcohol and force
- Once you're in its fairly easy to replace parts, but Nintendo don't supply parts
- Batteries are glued down, you need to destroy the foam beneath them to get the batteries out, Nintendo don't sell replacement foam, or even a specification for the foam
By being harder it will be more costly to repair
You need to undo glue, iFixit used isopropyl alcohol and force
This part I'm not so concerned about. It sucks but still doable.
Nintendo don't supply parts
Nintendo don't sell replacement foam
Yeah, see, that part I take issue with. That's not doable.
That's what I meant in my original comment.
The article is clickbaity and a bit crappy. The repair guide is not.
Welcome to the modern gaming press, I suppose.
From the teardown the only "corporate shenanigans" seem to be the usual soft security measures of hiding screws, having glue in a couple of places and using their security screws in the outer shell. I guess until we start seeing experimentation with swapping parts around we won't know if any pieces are signed to the board (something both Sony and Microsoft have been doing with optical media readers for ages, for example), but I'd be surprised. I assume iFixit have either tried or will try soon.
I think the difficulty matters, particularly for stick replacements. The Switch sticks weren't super easy to change but it was doable. I'd say this one is... harder. I'm hoping the sticks are more reliable, but I would seriously consider buying an aftermarket joycon before trying to replace a stick myself on this one. That's perhaps the one significant escalation I see here, and I will give it at least a bit of a pass in terms of difficulty because man, are the joycon insanely packed with stuff.
Ease of repair and cost effectiveness are literally the same thing.
They're literally not LOL.
If they glue in the battery it doesn't cost me anything extra to remove it.
Your time has no value? Can you do my laundry for me, then?
Every minute of my day does not have a monetary value, no. And if your does, I pity you.
Not all value is monetary, although it’s interesting that you default to assuming that.
You're the one that said it, not me
Also, can you please share your invention of this magical battery glue that actually removes cleanly with no fire risk and goes back cleanly to Nintendo and Apple? It’s cool that you’ve figured out how to do that even though these hardware manufacturers haven’t.
"magical" glue? I don't know what you're talking about.