deFrisselle @ deFrisselle @lemmy.sdf.org

Posts

13

Comments

201

Joined

2 yr. ago

Moderating

---

Make sure you update the firmware after setup I've seen alot of this solved by that Though there are some with bad boards

Also, have your Dad try out the new Mini firmware It's supposed to give a nice speed increase

Ah, good ol' FreeBSD
Runs our game systems, Netflix (30% of Internet traffic), and many other online services

Yes, as I am an Amiga user I've used it from very early on

This was my first PETG print It was on an upgraded Ender 3 Pro with Printed Solid Red PETG I just followed some advice online for the settings I did have have a few issue with PETG on my Sidewinder 2 and almost ruined the glass bed

I've never not had everything settle out and then just siphon it off with the bottling wand I do add some Bentonite

I use a 32" 60Hz monitor That's the way to go Level One Techs covered this due to those same reasons Wendel's mom's Smart TV ran out of storage for the OS Updates and some apps upgraded beyond working on the old OS It's like cell phones So, I went with a large cheap monitor on sale and stream from my PC or Roku stick It's basically built-in obsolescence

A heat pump and propane heat seem like a huge waste of money for duplications Plus where do I get the propane after it's banned

Too bad governments are not promoting Household Solar Systems for a decentralized grid

Battery, generator, or some systems work off the fuel pressure

Basically, you pick a bunch of oak leaves Rinse them Boil some water depending on the batch size Put oak leaves in a mesh bag then add to water AKA, make Oak Leaf Tea Add a little bit of ginger plus any other spices you'd like, then add the honey and yeast (after the must has cooled)

Yes, the later in the season they have less sugar and more tannins Just watch out if you get them very late, like right before they change color, as the excessive tannins will make it syrupy and will trap CO2 bubbles It can lead to exploding bottles or foaming when uncorked

So, what happens when high winds or a blizzard takes down the power lines

I lived through the 98' Ice Storm in the Northeast US Didn't have power for three weeks

Follow the Money for who funds these studies

In the early 90's my college had a VAX for student accounts via wonderful dial up The CS dept had Sparcstation 2 workstations

Atari VCS > VIC20 > C64> Amiga 500 > Amiga 1200 > Amiga 4000

I have with Cyser It greatly improved the flavor

Nice to have a sizable active community

I'm still hunting for a rPi 0 2 W so I can add a PiStorm to my Minimig Maybe later on for my A1200

That doesn't mean it was dry from the factory I've had spools this year from Polymaker that were fine for the first third then had issues symptomatic of wet filament

Never heard of that one but old printers, if in good condition, work just fine They might not understand some of the newer gcode commands but that's only a few Nero3D streamed a three-part series where he assembled and use an original Ultimaker from 2013 Barnacules Nerdgasm used a similar Ultimaker to print parts for a Voron 2.4 build Still very capable printers