You bet! My crown here, is 3d printed. I did about 3 cycles of filler and sanding because I got impatient and rushed and you can still see the print lines. Still looks good overall tho.
Sand before priming. And make sure you use filler primer! Will help a LOT. You will probably go through 3-4 cycles of sanding, filler, sanding, bondo, sanding then paint lol.
He is my own character. He was a soldier, later knighted after some heroic deeds. He helped save his kingdom and realm from an evil. The king died in the final battle, and due to his status, prominence and skill as a leader and general good nature he was made king of this kingdom. He became corrupted by his own power, taking the peoples admiration and worship too far and actually seeing himself as a god. He started abusing his power, and the people did not want to risk another evil like the one previously defeated. The people overthrew him and locked him up in a darkest deep dungeon to rot. Some indescernable amount of time later he is resurrected for reasons. However, it was botched, leaving him part skeletal and part bloated corpse (that last bit is mostly to excuse an overweight skeleton lmao, might omit that part when I lose weight). So yeahhhhh. I created this character and I'm using a fantasy novels universe my brother was writing ages ago to place his character and build his backstory.
Thank you! I've actually made some adjustments since this photo. Added some fur to the shoulders and around the neck, also some gold jewelry to give it more kingly vibes.
The crown is a replica of the crown from The Green Knight. I can't take credit for thay ingenious costume design. But I really wanted to use it in my own costume.
NOPE! I had an alternate version without the mask for actually enjoying the party lol.
This picture was taken before I finished all of the jewelry, but basically this is it.