Need advice for a 3D printer for 200-250€
Need advice for a 3D printer for 200-250€
I want to buy a 3D printer for about 200-250€ but I'm unsure which one to get. There are printers that a lot of people recommend but others say they're a piece of garbage.
The ones I found so far are these:
- Creality Ender 3 V3 SE - 182,94€
- Anycubic Kobra 2 Neo - 199,00€
- Sovol SV06 - 239,00€
There's also the open source firmware Klipper, which a lot people recommend but from what I understand, you need a Raspberry Pi for that. I do have a Pi 4 that I was planning to sell that I could use for that instead.
Would be great if some of you who know more than me could help me decide what to get.
You're viewing a single thread.
I’m not trying to bash any of these — just trying to expand your options. Have you looked at any used models of other printers?
Used might be a bad idea if they're new to printing. Few things are as frustrating as a printer on the fritz
Good point.