What's your favorite way to brew iced coffee in a Chemex?
Typically I'd make a pour over or espresso, but my A/C is out and I can't even think about hot coffee. What is your favorite way to make iced coffee in a Chemex? I've got light roasts from Costa Rica, Burundi, and Ethiopia right now.
Take half your total pour over water weight and put that amount of ice in the bottom of the Chemex.
Grind the usual amount of coffee for your Chemex brew.
Brew with whatever method you usually do but half the water weight for each pour (so you end up with the same amount of water as usual when you add the ice)
Instantly cold but full strength because the ice doesn't water it down when it melts!
Thanks for the tip! I tried this and ended up with an uneven extraction and slightly bitter cup—although that may be more due to the ratio than the brewing method. I typically brew pour overs at 1:17, but the recipe I found online was 1:4:7 ratio (48g coffee to 212g ice and 340g water). Since coffee extraction is non-linear, I don't understand how brewing with half the hot water yields the same extraction (based on the dynamics of coffee extraction). What brewing ratio worked produces a more balanced cup for you?
EDIT: I should add I ground medium-sized (3 on a Fellow Ode Gen 1) and used 99° C water.
I'd also recommend Hoffman's method, I grind quite a lot finer than I normally do, use closer to 1/11, and bloom for about a minute plus a slower pour.
Also I hold back 2-3 ice cubes and put them directly in my cup after serving. So instead of getting a lot of small almost melted cubes you have a few big ones making it nicer to drink.
I believe it's because I mostly drink delicate light roasted Ethiopian coffees that are a bit harder to extract for ice coffee.
I tried the Hoffman method today and it's quite good (provided you pour the iced coffee over additional ice before drinking). I didn't quite get a sweet fruit tea-like cup (like I usually do with a hot pourover light roast), but I certainly got more of the origin characteristics I was looking for.
When I do japanese iced, I usually grind a tiny bit finer, and pour as slowly as I can. Just so the brew time isn't halved. Not sure how proper that is, but it seems to work.
I usually do the 4:6 method when brewing pour over. Yeah it's older but I feel I get a more consistent cup even when I'm half asleep making it. Allowing most of the water to drain between pours seems to help with that. I've also done some wet WDT if the brew seems to stall to help make sure I meet my target brew time.
This is 100% the best way to quick brew iced coffee with any machine. I’ve made passably solid iced coffee in a drip machine that had the capability to turn the heating pad off.
Use a lot more ice than you’d think, by volume it’s very airy.