Installed Sprite Extruder Pro kit and Ender v2 Intelligent display, but both won't work properly
Installed Sprite Extruder Pro kit and Ender v2 Intelligent display, but both won't work properly
I own the Ender 3 Pro BUT, I have the silent motherboard 32-bit and installed with the firmware: "Ender-3 Pro_HW4.2.7_SW2.0.9.03_SpritExt_H300" because it seems like its the only one meant for the extruder pro kit. It complains that the BL-Touch is not attach to it. I can see it in Octoprint error message and gcode terminal.
- Firmware Source: https://www.crealitycloud.com/software-firmware/firmware?type=2
With the default firmware on it, it did manage to start the print till its heated to 228°C, but Octoprint couldn't proceed after the printer heated. It just waited till infinity.
Additionally the Display is not working at all, its beeping and mid beeping a louder beep is repeating every second. Not sure why, but the display claims to support Ender 3 Pro, Ender 3 and Ender 3 v2.
More Sources:
- Display: https://www.amazon.de/dp/B09292H22C
- Extruder kit: https://www.amazon.de/dp/B0B4NHNJ7K
- Silent Mainboard: https://www.amazon.de/dp/B07TY3HQ5H
What firmware would be the correct one for the extruder? Should I return the Display?
Silent Mainboard did work with the stock-extruder. It stopped working with Octoprint after replacing the extruder with the new one, but seems to heat and move correctly.
You're viewing a single thread.
I've installed the sprite pro on my ender 3 max. To get it going I compiled my own firmware and found that TH3D's firmware was simple and worked well.
Although it wasn't long and I added an rpi and installed Klipper.
For the bltouch, I didn't really spend time on it. The connector to the included board on the extruder didn't work - - I ran my own wire directly to the main board. Likely user error, but it's working so I stopped trying to fix it.
Hope this helps.