Skip Navigation

Cleaning build plate (was How hot is too hot for FDM printing?)

I recently had two print failures on my Ender 3 Neo. In both, it looked like the part came free from the heated build plate after about an hour or so of printing. Both had good starts in the first 15 minutes or so. I had a successful print finish two days ago.

It has been hot and humid here today, and my printer is in a non-AC shed not connected to the house.

I'm wondering if I should wait to kick off the next print until this evening when it should be cooler. Do I need to clean the build plate? I've not done that at all, other than make sure these isn't any filament left on the plate when it finishes.

UPDATE: It's apparent the problem isn't the heat, but the fact that I haven't cleaned the build plate since... well, ever. Adjusting the title to reflect that.

13

You're viewing a single thread.

13 comments
13 comments