Adhered so hard it delaminated the glass.

I loved this glass bed. After so much time trying to get anything to stick to the stock ender 3 bed, this glass bed has things sticking almost TOO well.

It was fine enough for PLA, but I've been playing with PETG lately and it sticks a little harder.

Well today I printed the entire bed flat for a little hiking table I'm experimenting with.. and this happened when I tried to get it off...

Suggestions for replacement? Should I go glass again? I don't have bltouch so I like how flat glass is, set it and forget it. But I've seen those magnetic plates that allow for super easy removal but just flexing the plate, but this bed is aluminum I think. Plus that seems similar to the stock ender 3 plate that I despise.