It heavily depends on the material if it will print fine at higher humidity, but having around 20-35 seems good afaik. I printed PLA successfully at around 55% for a long period before switching rooms and never had problems, but I wouldnt store PETG/TPU there without a sealed box
Whats wrong with the prusa? Considering getting one
Some found out that the camera feed isn't e2e encrypted (eufy claimed they were) so you could see other people cameras
Dont know if it will work, but I think it's worth a try. If it doesn't work you can reset it or swap it back
You could also use unifi, not cheap but you can run everything local afaik.
You could also say its AWS. They also should have the experience, but mistakes happen
Balcony solars are not able to back feed since they need the grid to synchronize, if you want one that is able to work in "island mode" you still need approval from the grid provider/one that isnt connected with the schuko connector.
They have enough energy, but they automatically turn off once the grid goes down because they need the grid to synchronize. Balcony solar panels are not able to work in "island mode", so no lineman is at risk.
Luckily I'm not in school anymore xD
But thx for correcting me, edited my post, should be correct now :)
You can get a 800Wp (max allowed Wp for a balcony solar) kit in austria for around 500€, germany is currently limited to 600Wp so it should be about the same price or cheaper. And you just need to plug them into a schuko outlet, so most people should be able to do it themselve.
Edit: Fixed units
I read once that crunchy also doesnt pay that much to the studios and its better to get the BD/DVD or other merch. Sadly dont have the source since its a few years ago that I read that article.
Its not that bad, its just all 5 seconds and not 2 seconds so no problem there! /s
I'm not only not buying a tesla because I'm not a fan of musk but also because I don't have the money ;)
Hyped for the new version of Spice and Wolf
